PS/PSE Installation Procedure

• Scrape off loose gravel, if gravel exists.

• Consult manufacturer of existing or new roofing system as to type of walk pads required for their roofing system.

• After pads are installed, place bases on pads

• Place frames over pipe to support and insert in bases

• Fasten frames to bases with supplied bolt & nut.

• With all pipe supports in place, start at beginning of system and adjust each strut/roller to achieve a balanced system. The process should be done in stages, raising the pipe ½" at a time. When desired height is reached, check each support to determine if and equal amount of weight is being distributed at each support.

• Installation per local, provincial or state Plumbing & Gas Code.